Beamz MHL 216 WASH Manual

2. Introduction2.1 Features• 15 channel DMX-512 .• Pan:585°, Tilt:315°• Variable electronic strobe.• Variable electronic dimmer(0-100%).• LED display menu with invert.• Reset to factory settings option.• Pan/tilt invert option.• Fan cooled.• Optional controllers.2.2 DMX channelChannel Function1 Pan2 Tilt3 Pan fine4 Tilt fine5 Pan/Tilt speed6 Master Dimmer7 Red (side1)8 Green (side1)9 Blue (side1)10 White (side2)11 White (side2)12 Amber (side2)13 Strobe14 Color Changer (side1)15 Color Changer (side2)3. SetupDisconnect the power cord before replacing a fuse and always replace with the same type fuse.3.1 Fuse replacementWith a flat head screwdriver wedge the fuse holder out of its housing. Remove the damaged fuse from itsholder and replace with exact same type fuse. Insert the fuse holder back in its place and reconnectpower.3.2 Fixture linkingYou will need a serial data link to run light show of one or more fixtures using a DMX·512 controller or torun synchronized on two or more fixtures set to a master/slave operating mode. The combined numberof channels required by all the fixtures on a serial data link determines the number of fixtures the datalink can support.Maximum recommended serial data link dislance:500 meters(1640ft).Maximim recommended number of fixtures on a serial data Iink:32 fixtures.Data cablingTo link fixtures together you must obtain data cables. If you choose to create your own cable please usedata-grade cables that can carry a high quality signal and are less prone to electromagnetic interference.