Beamz PartyBar9 Instruction Manual

4UNPACKING INSTRUCTIONCAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts arepresent, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection ifany parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packingmaterials. In the event that the product must be returned to the factory, it is important that the product be returned in the originalfactory box and packing.If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. Thearising condensation water might damage your device. Leave the device switched off until it has reached room temperature.POWERSUPPLYOn the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mainsvoltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must alsobe directly connected to the mains and may be used. No dimmer or adjustable power supply.Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriateelectrical ground to avoid the risk of electrocution or fire.INSTALLATIONAttention:• The installation of the product has to be built and constructed in a way that it can hold 10 times the weight for 1 hourwithout any harming deformation.• The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net. Thissecondary safety attachment must be constructed in a way that no part of the installation can fall down if the mainattachment fails.• Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing.• The operator has to make sure that safety-relating and machine-technical installations are approved by an expertbefore taking into operation for the first time and after changes before taking into operation another time.• The operator has to make sure that safety-relating and machine-technical installations are approved by a skilledperson once a year.• The fixture should be installed in the position where persons cannot reach and where persons may walk by or beseated.DISPLAYThe control board offer several features: you can simple set the starting address,run the pre-programmed program or make a reset. The main menu is accessedby pressing the Mode-button, browse through the submenu by pressing Up orDown.Press the Enter-button in order to select the desired menu.You can change the selection by pressing Up or Down. Confirm every selectionby pressing the Enter-button.You can leave every mode by pressing the Mode-button. The functions providedare described later in this manual.CAUTION: Please consider the respective national norms during theinstallation! The installation must only be carried out by anauthorized employee or dealers!CAUTION: When installing the device, make sure there is no highly ininflammable material (decoration articles, etc.) in between adistance of min 0.5 meter.