Beamz S1500 DMX Instruction Manual

Contents

Beamz S1500 DMX Instruction Manual Manual pdf 4 page image

- 4 -LocationSelect a location where it is easy to fill the tank. It is also possible to hang the unit by means of the supplied holder andfixing screws.Switching the unit offSwitch the unit off by unplugging it from the mains. Otherwise the 1500W heating element will draw unnecessarily current.Timer remote controlConnect the remote control to the connector on the back of the fogger.After some warm-up time, the device is ready for use, the LED will light up on the remote. During use, it may happen thatthe machine stops, in this case the LED will go out, indicating that the machine is warming up.Timer function:Press the yellow button and set the interval, duration and volume controls to the desired level.Interval: time between the smoke moments (10-200 seconds)Volume: amount of smoke (0-100%)Duration: duration of the smoking timeContinuous function:Press the red button and set the volume to the desired level. The machine will continueously produce an amount ofsmoke. It may be that the machine in between have to warm up, during this period no smoke is produced. How manytimes this is done depends on the amount of smoke.Manual Mode:Press the green button to produce 100% smoke immediately; this button overrides all previous settings.DMX controlConnect the device directly to a DMX controller or a DMX loop with multiple DMX effects. The machine has a 3-pin XLRconnector for DMX connection.Address Setup:Use the DIP switch on the rear panel to set the start address. The base/start address is defined as a first channel, whereresponsive to the device. Check if no overlapping channels are used!Example addressing:DMX address DIP on Value for DIP switch Diagram10 DIP 4DIP 282 (8+2 = 10)24 DIP 5DIP 4168 (16+8 = 24)233DIP 8DIP 7DIP 6DIP 4DIP 1128643281 (128+64+32+8+1=233)Note:It is necessary always lock a DMX loop with a 120 Ohm terminator for correct data transmission.CHANNEL VALUE FUNCTION1 0 – 100% Smoke level