Beamz WTR10 User Manual

Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present, andhave been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damage fromshipping or the package itself shows signs of mishandling. Save the package and all packing materials. In the event that the product must be returned tothe factory, it is important that the product be returned in the original factory box and packing.If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation watermight damage your unit. Leave the unit switched off until it has reached room temperature.The label on the backside of the unit indicates the mains voltage to which it must be connected. Check that the mains voltage corresponds to this. Anyother voltage than the one indicated may cause irreparable damage to the unit. The unit must also be connected directly to the mains voltage and nodimmer or adjustable power supply may be used.Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground toavoid the risk of electrocution or fire.1. DIRECTIONAL RECEPTION:Adjustable positioning for enhanced signal acquisition.2. IDENTIFICATION SWITCH:Utilized to configure the preferred protocol and either the transmission or reception mode.3. CONNECTION INDICATOR:Displays the status of the wireless link.4. DMX DATA INPUT:Utilizes a 3-pin XLR connector (pin1 = ground/shield; pin2 = data-; pin3 = data+).5. DMX DATA OUTPUT:Incorporates a 3-pin XLR connector (pin1 = ground/shield; pin2 = data-; pin3 = data+).6. POWER INLET:Equipped with a powercon port.