Becker Online Pro 7800 Installation Manual

Also see for Online Pro 7800: Update Operating guide

Contents

Becker Online Pro 7800 Installation Manual Manual pdf 18 page image

Subject to errors or technical changes 48 Copyright by Becker GmbH, D-76303 KarlsbadInstallation Guide10. Installation/ Removal of the OnlinePro• Installation:With this radio, a universal mounting for DIN installation slots isintegrated. An installation frame is not required. The unit is insert-ed into the installation slot and secured with the slides supplied.To install, complete all electrical connections. Then push the unitinto the installation slot. Subsequently, insert slides into the open-ings on the front of the unit until the first detent position (Fig. A).Now lock the radio in by pulling on both slides as shown in Fig. B.Subsequently, remove the slides.A The installation angle of the unit must not exceed 0° - 35°(vertical).• Removal:To remove the unit, it must first be unlocked. For this purpose,push in both slides to the second detent position, as shown in Fig-ure A. Subsequently, withdraw the unit with both slides. (Fig. C).Then remove the slides by pressing the springs on the right and leftsides of the unit.If the unit was installed previously in another vehicle, it may benecessary to adjust the springs on the unit before installation. Toadjust the springs, insert slide as shown in Fig. D and subsequentlyadjust as shown in Fig. E (Gently press slide in the direction of 1while at the same time moving the slide in the direction of 2).ABCDE12