Bellini BCA64CGP-W Installation & Operation Instructions

Contents

5the bracket to the hob. These screws MUST be securely tightened. Depends ondifferent models,there may be 4-5 pieces of brackets for the hob.Fitting guidelinesThe ceramic hob is manufactured to work with one-phasealternating current.The voltage rating of the ceramic hobheating elements is 220-240V. Adapting the ceramic hob tooperate with two-phase current is possible by appropriatebridging in the connection box according to the connectiondiagram below. The connection diagram is also found on thecover of the connection box. Remember that the connectionwire should match the connection type and the power ratingof the ceramic hob.The connection cable must be secured in a strain-relief clamp.Warning!Remember to connect the safety circuit to the connection box terminal markedwith .The electricity supply for the ceramic hob must have a safety switch whichenables the power to be cut off in case of emergency. The distance between theworking contacts of the safety switch must be at least 3mm.Before connecting the ceramic hob to the power supply it is important to read theinformation on the data plate and the connection diagram.wires for each domino hob with touch control modelsAdaptive voltage range and wires The wiring diagram220-240 1N～50-60Hz380-420 2N～50-60Hz KADO K 1/5H05VV-F 3G2.5 H05VV-F4G2.521