C. Crane CC QuickCharger-2 Instruction Manual
    | |
CC QuickCharger-2 Page 3Charging Batteries1. Insert 1 to 4 AA, AAA, C, D size or 1 to 2 9V rechargeable NiMH batteries into the batterycompartment, oriented according to the marked polarity (+ and –) symbols.2. Multiple sizes of batteries can be inserted at one time. The charger will adjust chargingcurrent for the different sizes automatically.3. Connect the supplied power adapter into the DC Power Input Jack on the back and plugit into your household electrical outlet.4. The LCD Display will indicate the charging status and the word “CHARGE” will be shown(see LCD Display Identification on page 2). The blue backlight will light up during thecharging process and turn off when charging has been completed.Note: 9V batteries will charge for 10 hours and shut off, no matter what the charge levelis. Make sure 9V batteries are fully drained before charging them again. The dischargefunction of the CC QuickCharger-2 will not discharge 9V batteries.5. When the batteries are fully charged, the word “FULL” will be displayed.6. Unplug the charger and remove the batteries. Do not leave batteries in the charger aftercharging cycle is complete.Discharging Batteries1. Insert 1 to 4 AA, AAA, C, or D size rechargeable NiMH batteries into the battery compart-ment, oriented according to the marked polarity (+ and –) symbols.2. Connect the supplied power adapter into the DC Power Input Jack on the back and plugit into your household electrical outlet.3. Press the “Discharge Button” located on the left side of the LCD Display. The LCD Dis-play will indicate the discharging status and the word “DISCHARGE” will be shown. Theblue backlight will light up during the discharging process.Note: The discharging process will not function if the “Discharge Button” is not pushedwithin the first minute of the charging cycle.5. The battery icons will continuously flash until all of the batteries have been discharged.6. After the batteries are fully discharged, the charging process will begin automatically andthe word “CHARGE” will be shown in the display to indicate the charging cycle status.USB Charge Function1. The USB Port can be used after a battery charging cycle is complete or there are no bat-teries in the charger compartment. The “USB Function Indicator” will be shown on thedisplay to indicate the USB Port is ready for use.2. Any USB device with a maximum load not exceeding 500mA can be charged. Plug aUSB cable into the USB Port and connect your desired device. (USB cable not included.)Bad Battery DetectionWhen the charge process has begun, the charger detects the status of each battery. If anyof the batteries are unsuitable for charging or inserted into the battery compartment incor-rectly, the word “BAD” will be displayed and the battery icon will flash. Remove the bad bat-tery or reinsert the battery correctly, if polarity is switched. |
Related manuals for C. Crane CC QuickCharger-2
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine