CAB MACH 4.3S/200B Service Manual

Also see for MACH 4.3S/200B: Operator's manual

112 Changing Assembly Parts56798612 13 126 161514 1410 1011Fig. 5 Changing the printheadRemoving the printhead1. Open the cover and fold the control panel (7) down. Push the energy regulator (5) and fold the printing module upwith the printhead retainer (6).2. Take the material out of the printer.3. Push against the printhead retainer (6) from underneath, lifting the mounting bracket (9) over the bar (8) and thendown through the slit.4. Pull the printhead retainer (6) out of the guide (11) of the printing module.5. Remove the printhead (13) by undoing the screws (12) of the printhead retainer (6).6. First remove the power cable (16) and then the data cable (15).Installing the printhead7. Connect the data cable (15), then the power cable (16) to the new printhead.8. Fasten the printhead (13) with the screws (12) to the printhead retainer (6).9. Place the printhead retainer (6) with the loop into the guide (11) and push it upward against the springs (10) wherethe springs should land on the indentations (14). Guide the mounting bracket (9) through the slit towards the topand over the bar (8) until it locks in place.10. Install the material once more, close the control panel and cover before use.! Attention!If there is a loss of quality visible on the printed label after the exchange of the printhead adjustments needto be performed.  3.3 on page 22.