CAB MACH1 Operator's Manual

CAB MACH1 Operator's Manual Manual pdf 22 page image

22 226.2 Error Alerts in Operation PanelIn the event of a problem that prevents normal functioning of the printer, you will see an error message on LEDindicators and hear some beep signals.Error LightColor: Flashing Frequency:• Red • Flashing• Light OnLED IndicatorLEDPowerLEDStatus Type Beeps Description SolutionPrint Head Error 2 x 4beepsThe printing mechanismis not closed correctly.Open the print mechanism andclose it again.Print Head Error None High temperature at theprint head.Once the print head has cooleddown, the printer switches tostandby mode.Media Error 2 x 3beepsNo ribbon is installed andthe printer displays anerror.Make sure that the printer is set todirect thermal printing mode.The ribbon is finished orthe label supply hub isnot moving.Replace the ribbon roll.Media Error 2 x 2beepsNo paper is detected.Make sure that the label sensor ispositioned correctly. If the sensorstill does not detect the paper, runthe auto-detection function again.Paper is finished. Replace the label roll.Printer feed problem.Possible reasons: the print mediumhas become trapped around therubber roll; the sensor cannot detecta gap or black mark between thelabels; there is no paper. Pleasereset the sensor.File Error 2 x 2beepsThe memory is full.The printer prints themessage "File Systemfull".Delete unnecessary data or installadditional memory.Unable to find file.The printer prints themessage "File Name NotFound" .Use the "~X4" command to print allfiles. Then check whether the filesexist and whether the names arecorrect.A file of the same namealready exists. The printerprints the message"Duplicate Name”.Change the name of the file and trystoring it again.Table 2 Error Alerts in Operation Panel6 Operation