CAME F500 Installation Manual

Also see for F500: Installation manual Quick start guide

6 714 89RG583TXRX25410Pag. 6 - Manual code: 119DS56EN119DS56EN ver. 55 01/2015 © CAME S.p.A. - The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME S.p.A. to notify users.ENGLISHMake sure you have all the tools and materials you will need for the installation at hand to work in total safety and compliance with thecurrent standards and regulations. The following figure illustrates the minimum equipment needed by the installer.N.B.: If the cable length differs from that specified in the table, then you must determine the proper cable diameter in the basis of theactual power draw by the connected devices and depending on the standards specified in CEI EN 60204-1.For connections that require several, sequential loads, the sizes given on the table must be re-evaluated based on actual power drawand distances.When connecting products that are not specified in this manual, please follow the documentation provided with said products.5.3 Cable list and minimum thicknessConnections Type of cable Type of cable Length of cable10 < 20 mLength of cable20 < 30 mControl panel power supply 230VFROR CEI20-22CEI EN50267-2-13G x 1,5 mm 2 3G x 2,5 mm 2 3G x 4 mm 2Motor power supply 24V 3G x 1,5 mm 2 3G x 1,5 mm 2 3G x 2,5 mm 2Flashing light 2 x 0,5 mm 2 2 x 1 mm 2 2 x 1,5 mm 2Photocell transmitters 2 x 0,5 mm 2 2 x 0.5 mm 2 2 x 0,5 mm 2Photocell receivers 4 x 0,5 mm 2 4 x 0,5 mm 2 4 x 0,5 mm 2Accessories power supply 2 x 0,5 mm2 2 x 0,5 mm 2 2 x 1 mm 2Control and safety devices 2 x 0,5 mm 2 2 x 0,5 mm 2 2 x 0,5 mm 2Antenna RG58 max. 10 m5.2 Tools and materials1) Gear motor unit2) Control panel3) Radio receiver4) Photocells5) Protruding key-operated selector switch6) Flasher7) Antenna8) Electric lock9) Transmitter10) Mechanical gate stop5.4 Standard installation