CARDIO STRONG EX60 Assembly And Operating Instructions Manual

Also see for EX60: Assembly and operating instructions

CARDIO STRONG EX60 Assembly And Operating Instructions Manual Manual pdf 7 page image

71.3 Electrical safety+ The equipment requires a 220 - 230V / 50 Hertz mains power supply.+ The equipment should be connected directly to a grounded plug socket only by means of thepower cable supplied. The use of multi-socket adapters or similar is not recommended. Extensionleads must comply with local electrical safety guidelines. Always fully unwind the power cable.+ The outlet should be secured with a fuse with a minimum value of „16 amperes, slow“.+ In order to reduce the risk of an electric shock, always unplug the equipment from the mainssocket immediately after your workout, before assembly or dismantling, and before maintenanceor cleaning. Do not pull on the cable.+ When plugged in, do not leave the equipment unattended at any time. To avoid use by anyoneunfamiliar with the operating instructions, the power cable should be removed when theequipment is not in use.+ Keep the power cable away from heat, oil and sharp edges. Do not route the power cableunderneath the equipment or under a carpet or rug, and do not place any objects on top of it.+ Make no modifications to either the power cable or the mains plug.+ If the power cable or the plug are damaged or defective, contact your authorized contractpartner. Do not use the equipment in the meantime.+ Do not keep electrical devices (e. g., mobile phones) in close proximity to the console or thecontrol electronics, otherwise display values (e. g., pulse measuring) could be inaccurate.1.4 Set-up place+ The equipment should only be used indoors, in a sufficiently heated and dry area (ambienttemperature between 10°C and 35°C). The equipment should not be used outdoors or in roomswith high humidity (over 70%) like swimming pools. The equipment should only be stored insurroundings with an ambient temperature between 5°C and 45°C.+ The training room should be well ventilated during training and not be exposed to any draughts.+ Choose a location in which to place the equipment such that there is enough free space/clearance to the front, the rear and to the sides of the equipment (at least 1.50 m). Furthermore,the equipment should not be set up in main entrances or on escape routes.+ Always keep the power cable away from hot surfaces and grounds and make sure that the cableis not stuck somewhere or becomes a „trip hazard“.+ No objects of any type should be inserted into the openings of the equipment.+ The equipment should be placed on a level and solid surface, any unevenness in the floor shouldbe leveled out.+ A floor protective mat / equipment underlay can help to protect high-quality floor coverings(parquet, laminate, cork, carpets) from dents and sweat and can help to level out slightunevenness.