CARDIO STRONG EX90 PLUS Assembly And Operating Instructions Manual

CARDIO STRONG EX90 PLUS Assembly And Operating Instructions Manual Manual pdf 8 page image

81.3 Electrical safety+ The equipment requires a 220 - 230V / 50 Hertz mains power supply.+ The equipment should be connected directly to a grounded plug socket only bymeans of the power cable supplied. The use of multi-socket adapters or similaris not recommended. Extension leads must comply with local electrical safetyguidelines. Always fully unwind the power cable.+ The outlet should be secured with a fuse with a minimum value of „16 amperes,slow“.+ In order to reduce the risk of an electric shock, always unplug the equipment fromthe mains socket immediately after your workout, before assembly or dismantling,and before maintenance or cleaning. Do not pull on the cable.+ When plugged in, do not leave the equipment unattended at any time. To avoiduse by anyone unfamiliar with the operating instructions, the power cable shouldbe removed when the equipment is not in use.+ Keep the power cable away from heat, oil and sharp edges. Do not route the powercable underneath the equipment or under a carpet or rug, and do not place anyobjects on top of it.+ Make no modifications to either the power cable or the mains plug.+ If the power cable or the plug are damaged or defective, contact your authorizedcontract partner. Do not use the equipment in the meantime.+ Do not keep electrical devices (e. g., mobile phones) in close proximity to theconsole or the control electronics, otherwise display values (e. g., pulse measuring)could be inaccurate.1.4 Set-up place+ The equipment should only be used indoors, in a sufficiently heated and dry area(ambient temperature between 10°C and 35°C). The equipment should not beused outdoors or in rooms with high humidity (over 70%) like swimming pools. Theequipment should only be stored in surroundings with an ambient temperaturebetween 5°C and 45°C.+ The training room should be well ventilated during training and not be exposed toany draughts.+ Choose a location in which to place the equipment such that there is enough freespace/clearance to the front, the rear and to the sides of the equipment (at least1.50 m). Furthermore, the equipment should not be set up in main entrances or onescape routes.+ Always keep the power cable away from hot surfaces and grounds and make surethat the cable is not stuck somewhere or becomes a „trip hazard“.