TMC-1-IMon Monitor Controller 2016 CB Electronics 3 ProvisionalIIMMoonnTMC-1-IMon User guideThis document only describes connection details and setup considerations when using I-Monand should be used with the TMC-1 User guide.TMC-1-IMon gain Structure

TMC-1-IMon User guide

GPO-3

Internal Talkback Microphone

Talkback and Sate Routing

RJ45 Breakout card

CB ELECTRONICS TMC-1-IMon User Manual

INTRODUCTION

CB ELECTRONICS

Connecting to XMon

Factory Default

Speaker Trim

Trim

OPERATION

Input Select/Mute

Speaker Solo Page

Information display: Shown Below

Auto Mode

User Keys, GPIO's and Auto

T/B, L/B, AFL Page: Key 5

TMC-1 C ONTROLS

User Function Keys

Knob Push

Display Keys [1] – [8]

Meter Page

User keys: [1], [5], [6], [8]

Mute

Solo

TALKBACK

Setup Menu

Menu 02 – Volume Knob push switch Function

Menu 05 – Talkback Latch Enable

Menu 08 – TFT Brightness

Adv Menu 01 – Lock/Un-Lock User Keys

Adv Menu 05, 06, 07, 08, 09,10 – GPI Inputs

Adv Menu 11 – AFL/PFL GPIO Input Active level

TMC-1-P ENTA A DVANCED M ENU ' S

TMC-1-XM ON A DVANCED M ENU ' S

GPIO

Connecting to the Avid

USB PORT

R ECOVERY

S ETTING THE TMC-1 USER KEY FUNCTIONS

TMC-1

CONNECTIONS

Power

XMon to HD-15 Converter

Connecting to D-Mon

SETTING UP TMC-1

P ROTECTED /C ALIBRATED S ETTINGS

I NPUT AND OUTPUT TRIMS

Using TMC-1v5 to adjust Trims

Mono Trim

Cal A/B Trim

Why is there no overall output level adjustment for the speaker sets

Power Amplifier Input Pad

Meters Page

Cue Sends Page

Select Page

Auto Mute

Auto Talkback

Dim] Key

USER FUNCTION KEYS

User Key-Common to All

TMC1-X MON O NLY

TMC-1-DM ON ONLY

TMC-1-AM ON ONLY

TMC-1-XM ON M ETER S OURCE

TMC-1-AM ON M ETER S OURCES

Cue Sends Display with [Select] depressed

Input Select keys [1]-[8]

Input Select page with Sum Enabled

Internal Talkback and Listen-back Latching

Auto-T/B & Auto Mute

Menu 3 – TFT Brightness

Menu 7 – Cue Output when Talkback Active

Menu 12 – Listen Speaker Output Assign

Adv Menu 04– External T/B Dim

Adv Menu 06 – Page key function

The default function for GP4 in is Ext T/B 2

Adv Menu 15 – AFL/PFL GPI Active level

Adv Menu 22 – Factory Reset

Adv Menu 23 – Alt Output Select

Adv Menu 24 – Digital Headroom

Adv Menu 27 – Write I/O Names To Penta / DAD AX/DX32

Adv Menu 23 – Digital Headroom

Adv Menu 27 – Communications

GPO Open Collector Outputs

GPI Inputs

hui emulation

Introduction

Part Names and Functions

Connection

Setting up the system

To set IP addresses

Precautions for a system with a Dante network

To assign a function to the User Keys

To set TMC-1 IP address

User Key List (Version 19612)

TMC-1-IMon


Contents Table Of Contents TMC-1-IMon User guide GPO-3 Internal Talkback Microphone Talkback and Sate Routing RJ45 Breakout card	TMC-1-IMon Monitor Controller 2016 CB Electronics 3 ProvisionalIIMMoonnTMC-1-IMon User guideThis document only describes connection details and setup considerations when using I-Monand should be used with the TMC-1 User guide.TMC-1-IMon gain Structure Previous Next / 10