Cabletime MediaStar 514 Quick Start Manual
  | |
Contents | 
RegulatoRy RequiRement noticesEuropECabletime Limited declare that the products described in this manual conform to the requirementsof the following Directives:• 89/336/EEC• 92/31/EEC• Low Voltage Directive 73/23/EECThE sTanDarDs appLiED arE:BSEN55022:1998 Limits and methods of measurement of radio interference characteristics ofinformation technology equipmentBsen50082-1:1998 electromagnetic compatibility - generic immunity standardBsen60950-1:2000 specification for safety of information technology equipment, including electricalbusiness equipmentBsen60065:2002 audio Video and similar electronic apparatus safety requirementsuniTED sTaTEs of amEriCaCabletime Limited declare this equipment has been tested and found to comply with the limits for a Class adigital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protectionagainst harmful interference when the equipment is operated in a commercial environment. This equipmentgenerates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with theinstruction manual, may cause harmful interference to radio communications. Operation of this equipment ina residential area is likely to cause harmful interference in which case the user will be required to correct theinterference at his own expense.• This device complies with part 15 of the FCC Rules.operation is subject to the following conditions:• This device may not cause harmful interference, and• This device must accept any interference received, including interference thatmay cause undesired operation.Whilst all reasonable care has been taken to ensure the accuracy of this publication, the publishers and authors cannotaccept responsibility for any errors and omissions. Cabletime Limited reserves the right to revise this publication and tomake changes in the content from time to time without notice.Copyright © Cabletime 2007. All rights reserved. No part of this guide may be reproduced, stored in a retrieval system ortransmitted in any form or by any means (electronic, mechanical, photocopying, recording or otherwise) without prior writtenpermission of Cabletime Ltd.Cabletime Limited, 64 Greenham Road, Newbury, Berkshire, RG14 7HX EnglandEmail: support@cabletime.comGetting Started With MediaStar 514 Wired Remote ControlThe MediaStar 514 Wired Remote Control can be used with all MediaStarsystems where a wired push button controller is required, rather than thestandard infra-red remote control and IR receiver. This unit connects to eitherthe MediaStar Evolution 760 and 760/xM units, MediaStar Pro 507 MicroSettops, or MediaStar Compact 751 receivers (all referred to as ‘endpoints’ inthis document).WHAT’S IN THE BOX• 514 Wired Remote Control• 514 Quick Reference CardQuick Start GuideimPoRtantThis unit has to be PROGRAMMED to operate correctly with eachtype of MediaStar endpoint equipment. Programming instructions areshown below. If this unit is plugged in but key presses do not get anyresponse from the system, it is likely the Wired remote Control hasbeen programmed to work with the wrong type of mediastar endpointequipment.3.5mm jackred LEDPage 4 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine