Cabletime MediaStar 514 Quick Start Manual
  | |
Contents | 
imPoRtant safety instRuctions1. Read these instructions.2. Keep these instructions.3. Heed all warnings.4. Follow all instructions.5. Do not use this apparatus near water.6. Clean only with a dry cloth.7. Do not block any ventilation openings. Install in accordance with themanufacturer’s instructions.8. Do not install near any heat sources such as radiators, heat registers, stoves orother apparatus (including amplifiers) that produce heat.9. Do not defeat the safety purpose of the polarised or grounding-type plug. Apolarised plug has two blades with one wider than the other. A grounding typeplug has two blades and a third grounding prong. The wide blade or the thirdprong are provided for your safety. If the provided plug does not fit into your outlet,consult an electrician for replacement of the obsolete outlet.10. Protect the power cord from being walked on or pinched particularly at plugs,convenience receptacles and the point where they exit from the apparatus.11. Only use attachments or accessories specified by manufacturer.12. Use only with the cart, stand tripod, bracket, or table specified by themanufacturer, or sold with the apparatus. When a cart is used, usecaution when moving the cart/apparatus combination to avoid injuryfrom tip-over.13. Unplug this apparatus during lightning storms or when unused for long periods oftime.14. Refer all servicing to qualified service personnel. Servicing is required when theapparatus has been damaged in any way, such as power-supply cord or plug isdamaged, liquid has been spilled or objects have fallen into the apparatus, theapparatus has been exposed to rain or moisture, does not operate normally, or hasbeen dropped.installationstart by removing the existing ir receiver module from the endpoint byunplugging its 3.5mm jack plug. For MediaStar Compact 751 units, the builtin ir receiver may be currently used, so there may be no external ir receiverjack plug to remove.Insert the 3.5mm jack plug of the Wired Remote Control into the endpoint’sjack socket.as each key is pressed, the red light on the front of the Wired remote Controlwill flash once. The MediaStar endpoint unit should respond in the samemanner as if the infra-red remote control is used. If it does not respond, thenthe appropriate ir address mode should be programmed into the Wired remoteControl Unit, as described below.Note: when using the 514 with a MediaStar Pro 507 unit using V6 (or earlier)software, use the INFO key instead of the NEXT key when prompted in the 507on-screen menus (pressing OK on the 514 will have no effect).PROGRAMMING THE IR ADDRESS1. Unplug the Wired Remote Control 3.5mm jack plug from the endpointunit.2. Press and hold down the Green and INFO buttons at the same time.3. Plug the 3.5mm jack cable back into the endpoint unit with the buttons stillpressed down. The red LED will then be illuminated to indicate the unit isin Programming Mode. Release the Green and INFO buttons.4. The unit is now awaiting entry of the MediaStar endpoint type to operatewith:• Press 1 for MediaStar Pro (507)• Press 3 for MediaStar Evolution (760, 760/xM)• Press 5 for MediaStar Compact (751)5. Once a number key has been pressed, the LED will flash thecorresponding number of times to confirm selection of that IR Address.6. The Wired Remote Control will then return to normal operation, with asingle LED flash each time a key is pressed.Page 2 Page 3 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine