Attaching the Strain Relief BracketPage 3-33.2.3 Attaching the Strain Relief BracketAttach the strain relief bracket to the front of the STH as follows:1. Locate the strain relief bracket and four 8-32 x 3/8" screws from theSTH-ACCY-KIT package.Warning: Use of longer screws may cause damage to the unit orelectrical shock.2. Carefully turn the STH upside down.3. Attach the strain relief bracket to the bottom of the STH as shown inFigure 3-2.Figure 3-2. Attaching the Strain Relief3.2.4 Rack-Mounting the STHPerform these steps to install the STH in a 19-inch rack:1. Remove the four cover screws (two from each side) located along thefront edges of each side of the STH.2. Using the four cover screws removed in step 1, attach the rackmounting brackets to each side of the STH as shown in Figure 3-3.3. With the mounting brackets installed, position the STH between thevertical frame members of the 19-inch rack and fasten it securely withthe mounting screws as shown in Figure 3-4.HubSTACKSTH-24TOKEN RING HUB with LANVIEW®SUPPORTING 100 OHM UTP CABLE16Mb/sPWRSTACKSPEED4M 16M24X 23X 22X 21X 20X 19X 18X 17X 16X 15X 14X 13X12X 11X 10X 9X 8X 7X 6X 5X 4X 3X 2X 1X