Cabletron Systems 9C214-2 Installation Manual

Contents

Installing the 9C214-2 Power Supply2-6Powering Up a 9C214-2 Power Supply1. Turn on the 9C214-2 Power Supply using the circuit breaker at the bottomright of the power supply. (The power supply uses a soft start feature anddoes a pre-power diagnostic check. Outputs become enabled within 5 secondsof power on.)2. Check to make sure thata. The PWR Status LED is green.b. The SMB Status LED is green.If the LEDs are any color other than green, refer to LANVIEW LEDs in Chapter 3.Before you power up a 9C214-2 Power Supply, make sure that the EnvironmentalModule and all modules have been properly installed.NOTE