Cabletron Systems 9C214-3 Installation Manual

Contents

2-3Installing the 9C214-3 Power SupplyPowering Up the 9C214-3 Power SupplyThe 9C214-3 Power Supply is powered up by following the steps below:1. Plug one end of the power cord (supplied with the power supply) into the ACpower socket on the lower right front corner of the power supply.2. Plug the other end of the power cord into an AC receptacle. Turn on the powersupply using the switch located near the power socket.3. The power supply uses a soft start feature and does a pre-power diagnosticcheck. Outputs become enabled within 5 seconds of turning the power on.4. Check to make sure thata. The PWR Status LED is green.b. The SMB Status LED is green.If the LEDs are any color other than green, refer to LANVIEW LEDs in Chapter 3.Before you turn the power switch on, make sure that the Environmental Module and allInterface Modules have been properly installed.NOTE