Cabletron Systems 9F122-12 User Manual

Also see for 9E531-24: User guide

Contents

2-3Installing the SmartSwitch 9000 ModuleAn eight-position DIP switch is located on the module card as shown inFigure 2-1. The function of the switches are listed in Table 2-1.See the Cautions at the end of this table.Table 2-1. Function of DIP SwitchSwitch Function Description8 ClearPassword 1When toggled, this switch clears user-enteredpasswords stored in NVRAM, and restores thedefault passwords. Once reset you can use thedefaults or enter new passwords.7 ClearNVRAM 2The module uses NVRAM to store user-entered parameters such as IP addresses,device name, etc. To reset these parameters tothe factory defaults, toggle this switch. Oncereset, you can use the defaults or enter newparameters, which are stored in NVRAMwhen the module is powered down, andremain there until the switch is toggled again.6 Force BootPDownloadToggling this switch after pulling the boardout of the SmartSwitch 9000, clears downloadinformation from NVRAM and forces imagefiles to be downloaded from the stationconnected to the EPIM on the EnvironmentalModule configured to act as that modules’BootP server. (See section titled Using DIPSwitch 6 on page 2-4.)5 Reserved For Factory Use Only4 Reserved For Factory Use Only3 Reserved For Factory Use Only2 Reserved For Factory Use Only1 Reserved For Factory Use Only1. Caution: Do not toggle Switch 8 unless you intend to reset the user-configured passwords to their factory default settings.2. Caution: Do not toggle Switch 7 unless you intend to reset the userparameters to the factory default settings.!CAUTION