Cabletron Systems CyberSWITCH CSX500 Setup Manual

Also see for CyberSWITCH CSX500: Configuration guide User guide

Contents

CSX500 Setup GuidePN 9032534-03Page 2 of 2QuickSet Utility: Configuring the CSX500Refer to the QuickSet QuickStart Guide located inside the QuickSet CD jewel case and follow the QuickSetprocedure to configure the CSX500.Full or Half Duplex Configuration on the LAN PortIf the version of QuickSet that you are running does not have the button in QuickSet to change the duplex setting,use the following procedure.The LAN port on the CSX500 is set to connect using half duplex by default. If a LAN connection is needed for fullduplex, the CSX500 must be configured using Network Tools. Refer to the Cabletron Systems Local ManagementUser’s Guide for CSX200, CSX400, CSX400-DC, HSIM-W6, and HSIM-W84 to configure the CSX500 usingNetwork Tools. Use the following procedure to set the port to full duplex:1. Use this OID to change the LAN port from the default of half duplex to full duplex:ctIf Duplex: 1.3.6.1.4.1.52.4.3.3.2.1.1.52. Set the OID string to 3 (full) in order to set the port to full duplex. Set the OID string to 2 (standard) for the portto be set to half duplex speed.GETTING HELPFor additional support, contact the Cabletron Systems Global Call Center: Copyright 1998 by Cabletron Systems, Inc., P.O. Box 5005, Rochester, NH 03866-5005All Rights Reserved. Printed in the United States of America.Cabletron Systems and QuickSet are registered trademarks, and SmartSwitch is a trademark of Cabletron Systems, Inc.NOTERefer to theRead Me First! instruction sheet enclosed with the device to ensure that your PC is ready forthe QuickSet configuration using the QuickSet CD.NOTEIf the LAN connection required is half duplex, and the port is configured for full duplex, the connectionmay appear to work, but problems can occur on the network. To prevent data corruption, change theconnection to the appropriate duplex setting.If a bootp download is required at full duplex speed, an internal DIP switch must be accessed andswitch 1 of the DIP switch set for the bootp to be successful. Refer to the Cabletron SystemsLocalManagement User’s Guide for CSX200, CSX400, CSX400-DC, HSIM-W6, and HSIM-W84 formore information on the bootp download procedure.World Wide Web http://www.cabletron.com/Phone (603) 332-9400Internet mail support@cabletron.comFTP ftp://ftp.cabletron.com/LoginanonymousPasswordyour email addressTo send comments or suggestions concerning this document, contact theCabletron Systems Technical Writing Department via the followingemail address: TechWriting@cabletron.comMake sure to include the document Part Number in the email message.

/ 2

Related manuals for Cabletron Systems CyberSWITCH CSX500