Cabletron Systems FRM Installation & Setup Manual

Also see for SmartSwitch 9000: Reference guide Appendix Appendix Appendix User guide

Contents

about this manual

Cabletron Systems reserves the right to make changes in s pecifications and other information con-tained in this document without prior notice. The reader should in all cases cons ult CabletronSystems to determine whether any such changes have been made.The hardware, firmware, and/or software described in this manual is s ubject to change withoutnotice.IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL,INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDINGBUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THISMANUAL OR THE INFORMATION CONTAINED IN IT, EVEN IF CABLETRON SYSTEMSHAS BEEN ADVISED OF, KNOWN, OR SHOULD HAVE KNOWN, THE POSSIBILITY OFSUCH DAMAGES.Copyright 1997, 1998 by Cabletron Systems, Inc. All rights reserved. Printed in the United Statesof America.See third-party software copyrights in the Frame Relay ModuleUser Guide.Statements of ComplianceFCCThe equipment provided by Cabletron Systems, Inc. and documented in this manual has been testedand found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCCRules. Thes e limits are designed to provide reasonable protection against harmful interferencewhen the equipment is operated in a commercial environment.This equipment generates, uses, and can radiate radio frequency energy and, if not installed andused in accordance with the installation manual, may cause harmful interference to radio commu-nications. Operation of this equipment in a residential area is likely to cause harmful interference,in which case the user will be required to, at his/her own expense, take the necessary measures toeliminate the interference.To ensure compliance with the Class A FCC limits, use only shielded cables with this equipment.Any cable installed above a ceiling or below a floor mus t be of a material and constructionapproved by UL for that application.DOC (Canada)This digital apparatus does not exceed the Class A limits for radio noise emissions from digitalapparatus set out in the Radio Interference Regulations of the Canadian Department of Communi-cations.Le present appareil numerique n'emet pas de bruits radioelectriques depassant les limits applicablesaux appareils numeriques de la class A prescrites dans le Reglement sur le brouillage radioelec-trique edicte par le ministere des Communications du Canada.Ins tallation & Setup Guide iAbout This ManualTerminology and ConventionsThis typeface represents general text. This typeface represents keyboar d input and videooutput.This symbol points to an informational note relating to the text, table, or figure thatimmediately precedes or follows it.This symbol and text identifies a cautionary note, the content of whichis more critical to heed than an informational note.References to keyboard keys appear as "[N]", where “N” is a specific key:Screen displays are provided to show the general appearance of actual screens. They are onlyexamples—they do not necess arily represent an operational system.Related DocumentsCopies of the Frame Relay Module Us er Guide and other Cabletron documents can be ordered fromCabletron Systems or your local distributor of Cabletron products.ii Frame Relay Module