Cabletron Systems MMAC-Plus 9T101-04 User Manual

Also see for MMAC-Plus 9T101-04: User guide

Contents

Cabletron Systems MMAC-Plus 9T101-04 User Manual Manual pdf 15 page image

2-3The Reset SwitchThe Reset SwitchThe Reset switch is located on the front panel, under the top plastic tab, as shownin Figure 2-2. It serves two functions:• Pressing the Reset switch twice within three seconds causes the processor toreset.• Pressing and holding the switch on for three or more seconds causes themodule to shutdown. Pressing and holding again for three seconds restarts themodule.SNMP management may be used to disable this switch to enhance modulesecurity.Figure 2-2. The Reset SwitchLocal Management ConsoleLocal Management is accessed by attaching a management console at the RJ-45CON port of the 9T101-04. The console connection supports a Digital EquipmentCorporation VT 320™ terminal or PC emulation of one of these terminals.Table 2-1 lists the setup requirements for the local management console. If yourterminal is a Digital Equipment Corporation VT 320™ terminal, press F3 to accessthe Setup Directory. If you have a terminal emulation of the Digital Equipmentterminals, refer to your equipment user manual for setup procedures.SMB CPUReset Switch