Cabletron Systems SmartSwitch 9000 User Manual

Also see for SmartSwitch 9000: Reference guide Appendix Appendix Appendix User guide

Cabletron Systems SmartSwitch 9000 User Manual Manual pdf 16 page image

Installing the SmartSwitch 9000 Module2-4Setting the Module Card DIP SwitchAn eight position DIP switch is located on the module card as shown inFigure 2-2. The functions of this switch are listed in Table 2-1.See the Cautions at the end of this table.Table 2-1. Function of DIP SwitchSwitch Function Description8ClearPassword 1 When toggled, this switch clears user-enteredpasswords stored in NVRAM, and restores thedefault passwords. Once reset you can use thedefaults or enter new passwords.7ClearNVRAM 2The module uses NVRAM to store userentered parameters such as IP addresses,device name, etc. To reset these parameters tothe factory defaults, toggle this switch. Oncereset, you can use the defaults or enter newparameters which are stored in NVRAM whenthe module is powered down, and remainthere until the switch is toggled again.6Force BootPDownloadToggling this switch after pulling the board outof the SmartSwitch 9000, clears downloadinformation from NVRAM and forces imagefiles to be downloaded from the stationconfigured to act as that modules’ BOOTPserver.5 Reserved For Factory Use Only4 Reserved For Factory Use Only3 Reserved For Factory Use Only2 Reserved For Factory Use Only1 Reserved For Factory Use Only1Do not toggle Switch 8 unless you intend to reset the user configured passwordsto their factory default settings.2Do not toggle Switch 7 unless you intend to reset the user parameters to thefactory default settings.!CAUTION