Cabletron Systems TPXMIM-20 Installation Manual

Also see for TPXMIM-20: Addendum manual

Cabletron Systems TPXMIM-20 Installation Manual Manual pdf 25 page image

TPXMIM Installation GuidePage 19CHAPTER 3INSTALLATION/CONFIGURATIONThis chapter contains instructions for:• unpacking the TPXMIM• installing the TPXMIM into a Multi Media Access Center (MMAC)• configuring the TPXMIM board or individual ports to run onMMAC backplane Channels• adding/replacing optional Ethernet Port Interface Modules• connecting your device to a network.3.1 UNPACKING THE TPXMIMUnpack the TPXMIM as follows:1. Remove the shipping material covering the TPXMIM.2. Carefully remove the module from the shipping box. Leave themodule in its non-conductive bag until you are ready to install it.3. Visually inspect the module. If you notice any signs of damage,contact Cabletron Systems Technical Support immediately.3.2 INSTALLING THE TPXMIMInstalling the TPXMIM into any MMAC hub is an easy operation andrequires no special skills or tools. However, when you install your device,keep the following in mind:• You may install the TPXMIM in any slot except for slot 1 (farthestslot to the right) of the MMAC chassis.