Cadillac 2008 Escalade Navigation System Owner's Manual

Also see for 2008 Escalade: Owner's manual Personalization guide

Cadillac 2008 Escalade Navigation System Owner's Manual Manual pdf 81 page image

• Background noise may cause voice commandsto be misunderstood, including airflow noisefrom wind.• To use the voice recognition system, the mapDVD must be loaded and the navigation systemmust be on.This system is able to recognize commands in threedifferent languages. The system will only recognizecommands based on the language selected from theDriver Information Center (DIC). See “Driver InformationCenter, DIC Vehicle Personalization” in the Index ofyour vehicles owner manual.Voice Recognition CommandsThe following list shows all of the voice commandsavailable for the navigation system with a briefdescription of each. The commands are listed with theoptional words in brackets. To use the voice commands,refer to the instructions listed previously.Voice Tag CommandsThe following are voice tag commands you can accessby clearly stating the commands exactly as they arewritten. You may have up to 40 voice tag entriesfor destinations.Navigation go to [destination], navigationselect: These commands instruct the system to selecta destination saved under the voice tag you havestored. The system will prompt you for a destinationname then wait for you to state the name.If you are not currently driving on a route, the systemwill automatically create the voice tag destination as thefinal destination. If you are currently driving on aroute, the system will automatically create the voice tagdestination as a stopover. Up to three stopovers canbe created.Storing Voice TagsFrom the address book entry information page, pressthe Add Voice tag screen button. The system willrespond “Name Please?” and you will have four secondsto record a name. The system will ask for confirmationof the name before saving it as a voice tag.Navigation HelpNavigation Help: This command instructs the systemto assist with navigation commands.Display CommandsUse the following display commands to set thedisplay mode.Display [set] day [mode]: Use this command to setthe display to daytime mode.4-3