18 — CONSTRUCTION MASTER ®P RO / TRIG / DESKTOPENTERING DIMENSIONSEntering Linear DimensionsWhen entering Feet-Inch-Fraction values, enter dimensions fromlargest to smallest — e.g., Feet before Inches, and Inches beforeFractions. Enter Fractions by entering the numerator (top), pressing/ (fraction bar key), and then the denominator (bottom).Note: If a denominator is not entered, the fractional setting value is used.Examples of Entering Linear Dimensions:DIMENSION KEYSTROKESClear calculator o5 Feet 1-1/2 Inch 5 f 1 i 1 / 2Clear calculator o5 Yards 5 yClear calculator o17.5 Meters 1 7 • 5 mEntering Square/Cubic DimensionsTheConstruction Master Pro lets you easily enter Square and Cubicvalues. Simply press a dimensional unit keytwo times to label anumber as a Square value, orthree times to label a Cubic value.Note: If you pass the desired dimensional format, keep on pressing the dimensionalunit key until the desired result is displayed again.Enter Square and Cubic dimensions in the following order:(1) Enter numerical value (e.g., 1 0 0).(2) Press desired unit key (e.g., f) to label value as “linear”.KEYSTROKE DISPLAYo o 0.1 0 0 f 100 FEET(3) Second press of unit key (e.g., f f) labels value as “Square”.KEYSTROKE DISPLAYo o 0.1 0 0 f f 100 SQ FEET(4) Third press of unit key (e.g., f f f) labels value as “Cubic”.KEYSTROKE DISPLAYo o 0.1 0 0 f f f 100 CU FEETNote: Feet-Inches format cannot be used to enter Square or Cubic values.
