Caliber MCD 165 Instruction Manual

Contents

Caliber MCD 165 Instruction Manual Manual pdf 9 page image

6. MENU OPERATIONSTIME SET (CLK)The time on the clock is set to “12:00” by default, Rotate the encoder volume knob toadjust the minutes and hours.Press AUDIO/MENU button to select the hour or minutes.Note: Time format can not to set up, it should be follow the tunner area to change, when isin U.S.A Latin then the time in 12H by default, when is in Europe Latin then the time in 24Hby default.LOCAL / DISTANTCERotate the encoder volume knob to select the strong local station ( Local Mode ), oraccess a wider range of using distant mode ( DX ).E - 8BEEP ON / OFFRotate the encoder volume knob to select Beep On / Off option.Beep Off: disable audible beep tone when any function is accessed.Beep On: enable audible deep tone.Programmable Turn-on Volume (P-VOL )This option allows selection of the volume level the radio will automatically assume whenfirst turned on. " P - VOL 40 " is the default setting, which will turn the radio on at the volumelevel selected when the unit was last turned off. To program a specific volume level for theradio to turn on at, rotate the volume control to select "VOLUME LEVEL”. Within 5 seconds.LOUD_OFFRotate the encoder volume knob select Loud On / Off to increase bass output, the defaultis Off.EQ_OFFTurn the encoder volume knob to select EQ Off to step through the follwing equalizeroptions:POP -> JAZZ -> CLAS -> BEAT -> ROCKBASS ( Bass level )Turn the encoder volume knob to adjust the desired Bass level range from -10 to +10, thedefault is “0”.TREBLE ( Treble level )Turn the encoder volume knob to adjust the desired Treble level range from -10 to +10, thedefault is “0”.BALANCERotate the encoder volume knob to adjust the Balance between the right and left speakersfrom R10 to L10, the “C00” is default.FADERRotate the encoder volume knob to adjust the Fader between the front and rear speakersfrom F10 to R10, the “C00” is default.To use this function keep press short AUDIO/MENU Button for few seconds, each time you pressthis button the mode will move and the functions will shown on the display, turn the encoder volumeknob up/ down to set the desires functions ,the function states as following:16) iX-BASS BUTTONPress the iX-BASS button to switch the loudness on or off. When Loudness is on,display willshow ‘Loud On’ for a few seconds.At DSP OFF mode, EQ will be controlled by Bass/Treble setting.