Caliber MCD-263 Instruction Manual

Contents

Caliber MCD-263 Instruction Manual Manual pdf 3 page image

Notes:- Choose the mounting location where theunit will not interfere with the normal drivingfunction of the driver.- Before finally installing the unit, connectthe wiring temporarily and make sure it is allconnected up properly and the unit and thesystem work properly.- Use only the parts included with the unit toensure proper installation. The use ofunauthorized parts can cause malfunctions.- Consult with your nearest dealer ifinstallation requires the drilling of holes orother modifications of the vehicle.- Install the unit where it does not get in thedriver's way and cannot injure thepassenger if there is a sudden stop, like anemergency stop.- If installation ang e exceeds 30°fromhorizontal, the unit might not give itsoptimum performancel- Avoid installing the unit where it would besubject to high temperature, such as fromdirect sunlight, or from hot air, from theheater, or where it would be subject to dust,dirt or excessive vibration.Din Front/Rear-MountThis unit can be properly installed eitherfrom 'Front' (conventional DIN Front-mount)or 'Rear' (DIN Rear-mount installation,utilizing threaded screw Holes at the sidesof the unit chassis). For details, refer to thefollowing illustrated installation methods.Installing the unitBe sure you test all connections first, andthen follow these steps to install the unit.1. Make sure the ignition is turned off, andthen disconnect the cable from the vehiclebattery's negative (-) terminal.5. The two supplied keys release tabsinside the unit's sleeve so you can removeit. Insert the keys as far as they will go (withthe notches facing up) into the appropriateslots at the middle left and right sides of theunit. Then slide the sleeve off the back ofthe unit.2. Disconnect the wire harness and theantenna.3. Press the button on the front panel andremove the control panel (For details, referto 'using the detachable front panel').4. Lift the top of the outer trim ring then pullit out to remove it.Installation OpeningThis unit can be installed in any dashboardhaving an opening as shown below:Installation1. DIN FRONT-MOUNT (Method A)53mm182mmTake Out Screw Before InstallationBefore install the unit, please remove thetwo screws.