Caliber MCD883 Operation Instructions Manual

Contents

15Installation GuideIf you are not sure how to install this unitcorrectly, contact a qualified technician.Installation Procedures1. Remove other audio system from the car.. Insert mounting collar into the dashboard.3. Attach the brackets to the main unit.Make sure to use the supplied flat headscrews (M5x6mm).4. Do the required electrical connections.5. Install the main unit in the dashboard.Make sure to use the supplied pan flathead screws (M.6x5mm).6. Turn on the unit and slide down the panel,then attach the trim plate.TroubleshootingIf you suspect something is wrong, immediately switch power off. Do not use the unit in abnormalcondition, for example without sound, or with smoke or foul smell, can cause fire or electric shock.Immediately stop using it and call the store where you purchased it. Never try to repair the unityourself because it is dangerous to do so.GeneralNo power or no sound.Car's engine switch is not on.Turn your car's key to ACC or ON.Cable is not correctly connected.Check connection.Fuse is burnt. Replace fuse.Check volume or mute on / off.If the above solutions cannot help.Press the RESET button.DiscDisc is inside but no sound.Disc is upside down.Place disc in the correct direction, and thelabel side up.Disc is dirty or damaged.Clean disc or change another disc.Disc sound skips, tone quality is low.Disc is dirty or damaged.Clean CD or change another CD.Sound skips due to vibration.Mounting angle is over 30o.Adjust mounting angle to less than 30o.Unstable mounting.Mount the unit securely with the mountingparts.RadioNoise in broadcasts.Station is too far, or signals are too weak.Select other stations of higher signal level.Preset station lost.Battery cable is not correctly connected.Connect the battery cable to the terminalthat is always live.

/ 16

Related manuals for Caliber MCD883