Caliber RMD 574BT Manual

Contents

RMD 574BT ManualBasic Operation1. Turning the unit on/offPress the POWER button to turn the unit on. Press and hold the POWER button again to turn off.2. Sliding out the monitorPress the TILT button so that the monitor will slide out automatically and the main GUI display will show up. Press the TILT button againso that the screen will go back in the chassis.3. Angle of the screenPress the UP/DOWN arrow buttons so that the screen will tilt up or down. There are 4 steps for tilting (ANGLE 0-4).4. Screen blackout / Video outputPress the POWER button once to turn the TFT off (when screen picture is not required). During video playback, the video signal willbe sent to connected monitor (if connected) so that the screen will show on these connected monitors. The TFT will be showing in lowresolution to indicate video output is in use.5. Day Light SavingTap the Day button on the OSD to increase brightness. Tap again to reduce brightness during night time. Tap again for black out thescreen.6. Mode SelectionPress the MODE Button to cycle the Play Modes between RADIO, USB, SD and AUX in.7. Sound ControlA. VolumeUse the VOL +/- Button to adjust the volume level. Turn the button clockwise to increase the volume, and vice versa. The larger the num-ber of volume, the higher the volume level. You can also adjust the volume by sliding the volume icon on top of the screen.B. BassPress the SEL Button until the display shows “BAS”. Use the VOL +/- Button to adjust. When EQ is ON, bass control is not available.C. TreblePress SEL Button until the display shows “TRE”. Use the VOL +/- Button to adjust. When EQ is ON, treble control is not available.D. BalancePress SEL Button until the display shows “BAL”, then use the VOL +/- Button to adjust the balance between the left & right speakers.E. Fader