phn-4755_002v006Page 3-2212. Verify that the wires ended up the correct order and that the wires extend to the front ofthe RJ45 plug and make good contact with the metal contacts in the RJ45 plug.13. Push back the CAT-5e or CAT-6 plug cover on the connector plug.NoteIt is recommended that the newly prepared cable be tested with a Cable Analyzer such asthe FLUKE DTX-1800 (or the equivalent), to make sure the cable complies withANSI/TIA/EIA-568-B-2. Make sure to verify both connectivity and grounding continuity atboth ends of the cable.Preparing the CAT-5e or CAT-6 Data Cable Already AssembledTo prepare the CAT-5e or CAT-6 cable already assembled:1. Release the gland cap and the gland rubber slightly.2. Insert the CAT-5e or CAT-6 cable into the gland cap and into the rubber gland.3. Insert the CAT-5e or CAT-6 cable into the gland body.
