Camco P Series User Manual

Contents

Camco P Series User Manual Manual pdf 19 page image

4 OPERATIONUSER MANUALTECTON POWER AMP SERIESP.74. Controls4.. Volume ControlA volume control with 4 notched settings controls the audio signal. Thesesettings have been selected to correspond to human hearing characteristics(logarithmically) and therefore guarantee an optimal range of settings for prac-tical applications. Each channel can be set individually except when operatingin mono modes whereby only channel A is active.Set the volume to zero before turning on the amplifier to prevent the occur-rence of sudden high volume levels which may cause damage to your hearingand/or the speakers.4..2 Gain SelectorA switch on the rear of the TECTON allows the maximum amplification attain-able to be set directly in the input stage.The TECTON amplifier has a 26 dB and 32 dBvoltage gain setting along with a ,4 V sensitivitysetting.4..3 Gain and Input SensitivityThe table shows input sensitivity per channel for a given gain and load. It alsoshows the gain for the ,4 V input sensitivity.Model 26 dB 32 dB 1,4 VTECTON 38.4 900 W @ 4 Ω00 W @ 8 Ω4,37 V4,70 V2,9 V2,36 V 36,52 dBTECTON 32.4 600 W @ 4 Ω95 W @ 8 Ω4,0 V4,29 V2,0 V2,5 V 35,72 dBTECTON 24.4 200 W @ 4 Ω700 W @ 8 Ω3,47 V3,75 V,74 V,88 V 34,56 dBTECTON 28.2 420 W @ 2 Ω920 W @ 4 Ω2,67 V3,04 V,34 V,52 V 32,74 dBTECTON 22.2 40 W @ 2 Ω660 W @ 4 Ω2,39 V2,58 V,20 V,29 V 3,29 dBTECTON 14.2 730 W @ 2 Ω420 W @ 4 Ω,92 V2,05 V0,96 V,03 V 29,33 dB4..4 Limiter SwitchThis switch is located at the rear of TECTON. It allows you to set the mode of thelimiter. There are three modes. (See 4.3.1 Clip Limiter)Right position: Middle position: Left position:Clip Limiter: Fast Clip Limiter: Slow Clip Limiter: OffAttack fast Attack slow