Campbell Hausfeld IN630101AV Operating Instructions Manual

Also see for HL5401 Series: Quick setup instructions Quick setup instructions

Contents

Campbell Hausfeld IN630101AV Operating Instructions Manual Manual pdf 6 page image

6Operating Instructionswww.chpower.comMaintenance (Continued)Intake aIr FILter MaIntenanCeRemoval, Inspection and Replacement(Figure 9).The intake filter element should beremoved and checked periodically.A clogged intake filter can decreasecompressor performance and cause thecompressor to overheat.1. Rotate the filter cover counter-clockwise and remove.2. Remove the filter element andinspect.3. If the filter element is dirty orclogged, replace it.4. Reinstall filter and cover.IMpOrtant: Locate unit as far fromspraying area as hose will allow toprevent overspray from clogging filter.enD OF OperatIOn/StOraGe1. Turn AUTO/OFF switch to the OFFposition.2. Unplug power cord from wall outletand wrap around handle to preventdamage when not in use.3. Wearing safety glasses drain tank ofair by pulling the ring on the safetyvalve. Use other hand to deflectfast moving air from being directedtoward your face.4. Drain tank of condensation byopening drain valve on bottom oftank. Tank pressure should be below10 psi when draining tank.5. Air hose should be disconnectedfrom compressor and hung openends down to allow any moisture todrain.6. Compressor and hose should bestored in a cool, dry place.teCHnICaL ServICeFor information regarding theoperation or repair of this product,please call 1-800-543-6400.MaIntenanCe SCHeDULeOperatIOn DaILy WeekLy MOntHLy 3 MOntHSCHECK OIL LEVEL lDRAIN TANK lCHECK AIR FILTER lCHECK SAFETY VALVE lCLEAN UNIT lCHANGE OIL lFigure 9 - Intake Filter MaintenanceFilterElement FilterCoverMOIStUre In COMpreSSeD aIrMoisture in compressed air will forminto droplets as it comes from an aircompressor pump. When humidityis high or when a compressor is incontinuous use for an extendedperiod of time, this moisture willcollect in the tank. When using apaint spray or sandblast gun, thiswater will be carried from the tankthrough the hose, and out of thegun as droplets mixed with the spraymaterial.IMpOrtant: This condensation willcause water spots in a paint job,especially when spraying other thanwater based paints. If sandblasting, itwill cause the sand to cake and clogthe gun, rendering it ineffective.A filter in the air line, located asnear to the gun as possible, will helpeliminate this moisture.