Switch off the electricity supply and allow to cool before cleaning the cooker.Clean the cooker regularly and wipe up spills soon after they occur to preventthem from becoming burnt on. Never use biological washing powder, causticcleaners, harsh abrasives, scouring pads, steam cleaners, aerosol cleaners or ovenchemical cleaners of any kind.Before moving your cooker ensure that it is cool and note that it is heavy(approximately 70 kg 155 lbs), so you may require assistance. To move the cookerforward, open the top oven/grill door and with both hands positioned under the roofof the compartment, lift and pull forward. Replace by pushing the cooker backwards.Check that the cooker is level. Take care to ensure that any floor covering is not dam-aged.MAIN OVEN HEAT CLEAN LININGSThe oven back and side linings are coated with a special enamel which has acontinuous cleaning action. The higher the oven temperature the more effective theaction. In most cases this cleaning operation will proceed during normal cooking.However, if roasting is done frequently, or high temperatures are not used regularly, itmay be necessary to run the oven empty at Mark 8 for about two hours.It should not normally be necessary to clean the linings with water, but if desired, wipethem over with a soapy cloth, followed by a wipe with a damp clean cloth.REPLACEMENT OF OVEN LIGHT BULBCAUTION: DISCONNECT THE APPLIANCE FROM THE ELECTRICITY SUPPLY BEFOREREPLACING THE LAMP TO AVOID THE POSSIBILITY OF AN ELECTRIC SHOCK.Light bulbs are not covered by the manufacturer’s guarantee.A new 15W, 300˚C rated SES bulb can be obtained from your cooker supplier or anymajor electrical retailer.1. Remove the shelves from the oven.2. Unscrew the lens using a thick cloth to protect your fingers in the unlikely event ofa lens fracture.3. Unscrew bulb.4. Fit new bulb and refit lens.24CARE AND CLEANING