Canon AK1 Operation Manual

Also see for AK1: Service manual

Contents

NOTE• The saddle stitch mode is only available when Saddle Finisher-AK2 is installed.• The maximum number of sheets that can be saddle stitched differs depending on the paperweight and type.• When you use plain paper (80 g/m² / 20 lb bond), 25 sheets of paper (100 pages) can be saddlestitched at once.• The paper sizes that can be saddle stitched are: A3/Tabloid, A4R/LTRR, 304.8 mm × 457.2 mm(12" x 18"), 320 × 450 mm (12.6" x 17.7") (SRA3), 330.2 mm × 482.6 mm (13" x 19"), and customsizes (210 mm × 279.4 mm to 330.2 mm × 487.7 mm / 8.3" x 11" to 13" x 19.2").• The accuracy of folds created in the saddle stitch mode can vary depending on the paper typeand the number of sheets.Punch modeThe punch mode allows you to punch your documents. The number of holes depends on the typeof puncher unit installed.NOTE• The punch mode is only available when the Puncher Unit-BT1/BU1 is installed.• The Puncher Unit-BT1 can punch holes in the following paper:Two Holes: A3, A4, A4R, custom size (182 mm x 182 mm to 297 mm x 432 mm / 7.2" x 7.2" to11.7" x 17").Four Holes: A3, A4R, custom size (257 mm x 182 mm to 297 mm x 432 mm / 10.1" x 7.2" to11.7" x 17").• The Puncher Unit-BU1 can punch holes in the following paper:Four Holes: A3, A4, A4R, custom size (257 mm x 182 mm to 297 mm x 432 mm / 10.1" x 7.2" to11.7" x 17").• Holes cannot be punched in transparencies, labels, or pre-punched paper.When you carry out a copy job, the hole punched areas are shown in the illustration below.Legend for the illustration aboveEnglish text TranslationPlaten Glass Glass plateFeeder ADFHole Punched Area Hole Punched AreaIf you use Puncher Unit-BT1, the distance between the punch holes is shown in the illustrationbelow.The illustration on the left shows the distance for two holes. The illustration on the right showsthe distance for four holes.The finishing modesChapter 3 - Use the stacker/stapler 17Canon Finisher-AK1/Saddle Finisher-AK2/Puncher Unit-BT1/BU1Operation Guide Finisher-AK1, Saddle Finisher-AK2, Puncher Unit-BT1-BU1: VarioPrint (VP) 110, VP120, VP135 - Edition 2013-06