Canon EF-S10-18mm f/4.5-5.6 IS STM User Manual

Also see for EF-S10-18mm f/4.5-5.6 IS STM: Instructions Instructions

CT1-8602-000 1407SZ © CANON INC. 2014●❹3. Hood (Sold Separately)The ES-52 hood can keep unwanted light out of the lens, and also protects thelens from rain, snow, and dust.When attaching the hood, securely attach it to the filter mounting thread (ø52mm)on the front of the lens, or to the thread (ø52mm) on the front of the filter that isalready fitted to the lens (excluding older Canon circular polarizing filters that donot have a filter mounting thread on the front) ❹ .Part of the picture may be blocked if the hood is not attached properly.4. Filters (Sold Separately)You can attach filters to the front of the lens, or to the filter mounting thread(ø52mm) on the front of the hood.● Only one filter may be attached.● Use the Canon Circular Polarizing Filter PL-C B (ø52mm) as thepolarizing filter.● You can use hoods and filter attached in any order.5. Extension Tubes (Sold Separately)You can attach extension tube EF12 II or EF25 II for magnified shots. Forshooting distance and magnification, see the extension tube specifications.MF mode is recommended for accurate focusing.● The lens length is measured from the mount surface to the front end of thelens. Add 23.9 mm when including the lens cap and dust cap.● The extenders cannot be used with this lens.● The close-up lenses cannot be used with this lens. (The end of the lens willbecome heavy, causing the focus to become unstable.)● CASE (Sold Separately) LP811This device complies with Part 15 of the FCC Rules. Operation is subject to thefollowing two conditions: (1) This device may not cause harmful interference,and (2) this device must accept any interference received, including interferencethat may cause undesired operation.Do not make any changes or modifications to the equipment unless otherwisespecified in the instructions. If such changes or modifications should be made,you could be required to stop operation of the equipment.This equipment has been tested and found to comply with the limits for a classB digital device, pursuant to part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmfulinterference in a residential installation. This equipment generates, uses andcan radiate radio frequency energy and, if not installed and used in accordancewith the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment off andon, the user is encouraged to try to correct the interference by one or more ofthe following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to whichthe receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.CAN ICES-3(B)/NMB-3(B)Specifications * Sold SeparatelyAngle of view Lensconstruction Minimumaperture Max.magnification Min. focusingdistance Filter diameter Max. diameter and length Weight Hood* Lens Cap Case*Diagonal Vertical HorizontalEF-S24mm f/2.8 STM 59°10’ 34°55’ 50°35’ 5-6 22 0.27x 0.16m/0.52ft 52mm 68.2x22.8mm (2.7”x0.9”) 125g/4.4oz. ES-52 E-52 II LP811Extension Tube Specifications(Sold Separately)Magnification(X)Focusing Distance Range(mm) (inch)EF-S24mm f/2.8 STM EF12 II 0.77-0.50 114-125 (4.5-4.9)EF25 II 1.38-1.11 115-112 (4.5-4.4)COPY

/ 16

Related manuals for Canon EF-S10-18mm f/4.5-5.6 IS STM