337If there is a problem with the camera, anerror message will appear. Follow the on-screen instructions.* If the error still persists, write down the error number and contact yournearest Canon Service Center.Error CodesNumber Error Message and Solution01Communications between the camera and lens is faulty. Clean thelens contacts.Î Clean the electrical contacts on the camera and lens or use aCanon lens (p.17, 20).02Card cannot be accessed. Reinsert/change card or format cardwith camera.Î Remove and insert the card again, replace the card, or format thecard (p.31, 48).04Cannot save images because card is full. Replace card.Î Replace the card, erase unnecessary images, or format the card(p.31, 268, 48).05The built-in flash could not be raised. Turn the camera off and onagain.Î Operate the power switch (p.34).06Sensor cleaning is not possible. Turn the camera off and onagain.Î Operate the power switch (p.34).10, 20,30, 40,50, 60,70, 80,99Shooting is not possible due to an error. Turn the camera off andon again or re-install the battery.Î Operate the power switch, remove and install the battery packagain, or use a Canon lens (p.34, 30).Error numberCountermeasureswww.devicemanuals.euError Message and Solutionwww.devicemanuals.euError Message and Solutionwww.devicemanuals.euCommunications between the camera and lens is faulty. Cwww.devicemanuals.euCommunications between the camera and lens is faulty. Cwww.devicemanuals.euthe camera and lens or use awww.devicemanuals.euthe camera and lens or use awww.devicemanuals.euCard cannot be accessed. Reinsert/change card or formawww.devicemanuals.euCard cannot be accessed. Reinsert/change card or formawww.devicemanuals.euRemove and insert the card again, replace the card, or formatwww.devicemanuals.euRemove and insert the card again, replace the card, or formatwww.devicemanuals.euCannot save images because card is full. Replace carwww.devicemanuals.euCannot save images because card is full. Replace carwww.devicemanuals.euReplace the card, erase unnecessawww.devicemanuals.euReplace the card, erase unnecessa(p.31, 268, 48).www.devicemanuals.eu(p.31, 268, 48).www.devicemanuals.euThe built-in flash could not be rawww.devicemanuals.euThe built-in flash could not be rawww.devicemanuals.euwww.devicemanuals.euwww.devicemanuals.euwww.devicemanuals.euwww.devicemanuals.euwww.devicemanuals.euwww.devicemanuals.eu
