291General Live View Shooting CautionsLive View Image Under low- or bright-light conditions, the Live View image may not reflectthe brightness of the captured image. Even if a low ISO speed is set, noise may be noticeable in the displayedLive View image under low light. However, when you shoot, the imagerecorded will have less noise. (The image quality of the Live View imageis different from that of the recorded image.) If the light source (illumination) within the image changes, the screenmay flicker. If this happens, exit Live View shooting and resume LiveView shooting under the actual light source. If you point the camera in a different direction, it may throw off the LiveView image’s correct brightness momentarily. Wait until the brightnesslevel stabilizes before shooting. If there is a very bright light source in the image, the bright area mayappear black on the LCD monitor. However, the actual captured imagewill correctly show the bright area. In low light, if you set the [52: LCD brightness] to a bright setting, noiseor irregular colors may appear in the Live View image. However, thenoise or irregular colors will not be recorded in the captured image. When you magnify the image, the image sharpness may look morepronounced than in the actual image.Custom Functions During Live View shooting, certain Custom Function settings will not takeeffect (p.411).Lens and Flash If the attached lens has an Image Stabilizer and you set the ImageStabilizer (IS) switch to <1>, the Image Stabilizer will operate at alltimes even if you do not press the shutter button halfway. The ImageStabilizer consumes battery power and may decrease the number ofpossible shots depending on the shooting conditions. When the ImageStabilizer is not necessary, such as when using a tripod, it isrecommended to set the IS switch to <2>. The focus preset function is possible for Live View shooting only whenusing a (super) telephoto lens equipped with the focus preset modereleased in and after the second half of 2011. FE lock will not work if the built-in flash is used. FE lock and modelingflash will not work if an external Speedlite is used.
