25If you set the power to <1> and the time zone/date/time settingscreen appears, see page 27 to set the time zone and date/time.Pressing the power button toggles between<1> and <2>.With the power <2>, holding down the<x> button for 2 sec. or longer will start theplayback mode.When an EF-M lens is attached to thecamera and the power is off, the aperturestops down to shut out the light andprotect the inside of the camera. Whenyou set the power to <1> or <2>,the aperture makes a small noise as itopens.To save power, the LCD monitor turns off automatically if you do notoperate the camera. If you continue to not operate the camera, the powerwill turn off automatically. While the LCD monitor is off, pressing anycamera button or tapping the LCD monitor will turn it on again. If the powerturned off, either press the power button or press the <x> for at leastapprox. 2 sec. to turn on the power again.You can change the LCD monitor auto off time and Camera auto off timewith [LCD auto off] and [Camera auto off] under [52: Power saving](9?).Turning on the Power3 Power-saving FeaturesIf you set the power to <2> while an image is being recorded to the card,[Recording...] will be displayed and the power will turn off after the card finishesrecording the image.
