Acquiring GPS Signals101 Select [GPS device settings].2 Set [GPS device] to [Enable].If the [Calibrate digital compass]screen is displayed, follow steps 6 – 7on p.16.Viewing GPS InformationSignal acquisition takes about 30 – 60 seconds under favorableconditions after you turn the camera on.After initial signal acquisition, signals can be reacquired soon after thecamera is turned on again (under favorable conditions, and when thecamera has been off for less than approx. 30 minutes).Places with Poor GPS CoverageLocation information may not be recorded, or inaccurate information may berecorded where GPS signal coverage is poor, such as in the followingplaces.Indoors, underground, in tunnels or forests, near buildings or in valleysNear high-voltage power lines or mobile phones operating on the1.5 GHz bandWhen traveling through different environmentsEven in other places, GPS satellite movement may interfere withgeotagging and cause missing or inaccurate location information. Theinformation may also indicate that the camera has been used in adifferent location, even if you were shooting at the same place.Appended InformationIf shooting is performed immediately after turning on the camera’s powerswitch (or resuming use after auto power off) when the receiver isattached to the camera, images may not be geotagged. Similarly,directions may not be recorded correctly. To avoid this, wait a momentbefore shooting.COPY
