Canon HR10 Instruction Manual

Also see for VIXIA HR10: Software guide Instruction manual Brochure Instruction manual Instruction manual

Canon HR10 Instruction Manual Manual pdf 103 page image

103PrintingOthersList of MessagesProblem SolutionThe printer is not operating eventhough the camcorder and printer arecorrectly connected.Disconnect the USB cable and turn off the camcorder and the printer. Aftera short while, turn them on again, set the camcorder to modeand restore the connection.–Problem SolutionA rattling can be heard from thecamcorder.The internal lens fixture can move when the camcorder is turned off. Thisis not a malfunction.–Message ExplanationCHANGE THE BATTERY PACK Battery pack is exhausted. Replace or charge the battery pack. 20CANNOT ENTER THESTANDBY MODE NOWThe camcorder cannot enter the standby mode while the disc is beingrecognized after first inserting it or if the remaining battery charge is too low.36UNABLE TO RECOGNIZE THERECORDING MODE OF THE DISCYou inserted a type of disc not supported by this camcorder. 3The disc may not be recognized by this camcorder if it was initialized orrecorded using a different device.–You inserted a disc recorded in a different television system (NTSC). –• TEMPERATURE TOO HIGHCANNOT RECORD• TEMPERATURE TOO HIGHCANNOT REMOVE DISCThe camcorder has exceeded its operational temperature. Disconnect thecompact power adapter and remove the battery pack. Let the camcorder cooldown before resuming use.–• CANNOT RECORD• CANNOT RECORDCHECK THE DISCThere is a problem with the disc. Replace the disc. 29This message can also appear if condensation has formed. Wait until thecamcorder dries completely before resuming use.111The disc’s recording surface may be dirty or scratched. –REACHED THE MAXIMUMNUMBER OF SCENESThe maximum number of scenes has been reached. Delete some recordings(DVD-RW in HD quality, or SD quality (VR mode)) to free some space or replacethe disc.40CANNOT PLAY DISC The disc is dirty or you attempted to play back a type of disc not supported bythis camcorder.3This message can also appear if condensation has formed. Wait until thecamcorder dries completely before resuming use.111