Back Previous Page Next PageContentsDR-2010C / DR-2510CDR-2010C / DR-2510C50This section describes the procedure for setting to omit borders and ruled linesof a specified color (red, green, or blue) from the scanned image.NOTEIf you select [24-bit Color] or [Auto Color Detection] from the [Mode] drop-downlist in the [Basic] tab, you cannot specify this setting.1 In the ISIS/TWAIN driver properties dialog box, click the [Imageprocessing] tab → select the color to omit from the [Front] and [Back]drop-down lists under Color drop-out, as necessary.NOTEYou can specify different settings for the front and back side of the document.This section describes the procedure for setting the scanner to enhance the redcolor when performing black-and-white scanning.NOTEIf you select [24-bit Color] or [Auto Color Detection] from the [Mode] drop-downlist of the [Basic] tab, you cannot specify this setting.1 In the ISIS/TWAIN driver properties dialog box, click the [Imageprocessing] tab → select [Red Enhance] from the [Front] and [Back]drop-down lists under Color drop-out.NOTEYou can set specify different settings for the front and back side of the document.Omitting a Specific Color Enhancing the Red Color
