4-on-1 PrintingPrints four pages of the document, side by side, on one sheet of paper.To change the page sequence, click the Page Setup tab, select Page Layout for Page Layout,and click Specify.... Then in the Page Layout Printing dialog box that appears, specify the PageOrder.Duplex Printing (Manual)Select whether to print the document to both sides of the paper manually or to one side of thepaper.To change the staple side or the margins, set the new values from the Page Setup tab.Grayscale PrintingThis function converts the data to monochrome data when printing your document.DraftThis setting is appropriate for test printing.Rotate 180 degreesPrints the document by rotating it 180 degrees against the paper feed direction.The width of print area and the amount of extension that are configured in other applicationsoftware will be reversed vertically and horizontally.Color/Intensity Manual AdjustmentSelect when you set the Color Correction method and individual settings such as Cyan, Magenta,Yellow, Brightness, Intensity, and Contrast, etc.Media TypeSelects a type of printing paper.Select a media type that matches the paper that is loaded in the printer. This ensures that printing iscarried out properly for the specified paper.Printer Paper SizeSelects the size of paper actually loaded into the printer.Normally, the paper size is set automatically according to the output paper size setting, and thedocument is printed with no scaling.When you set 2-on-1 Printing or 4-on-1 Printing in Additional Features, you can manually set thepaper size with Page Size on the Page Setup tab.If you select a paper size that is smaller than the Page Size, the page image will be reduced.If you select a paper size that is larger than the Page Size, the page image will be enlarged.OrientationSelects the printing orientation.If the application used to create your document has a similar function, select the same orientation thatyou selected in that application.PortraitPrints the document so that its top and bottom positions are unchanged relative to the paper feeddirection. This is the default setting.LandscapePrints the document by rotating it 90 degrees relative to the paper feed direction.You can change the rotation direction by going to the Maintenance tab, opening the CustomSettings dialog box, and then using Rotate 90 degrees left when orientation is [Landscape]check box.To rotate the document 90 degrees to the left when printing, select the Rotate 90 degrees leftwhen orientation is [Landscape] check box.186
