| 
9-16TroubleshootingError MessagesError MessagesSee the table below when the error and status messages appear on the display.Message Description ActionCHANGE REG’D SIZE→ PAPER SETTINGSThe paper size is not appropriate for 2-sidedcopying.Set the paper size to or . Fordetails, see “Setting Paper Size and Type,” onp. 2-14.CHECK DOCUMENT A document jam may have occurred in theADF.Remove the jammed document.CLOSE COVERTONER COVERThe toner cover is not closed completely. Check the toner cover, and make sure that itis completely closed.LIFT PANEL TO OPENOPEN TONER COVERAppears alternately with other messages. Varies by the message that appears. Fordetails, see the explanation for the message(i.e., ).LOAD CORRECTPAPERThe size of the paper in the paper cassetteor multi-purpose tray is different from thatof the paper specified in for or .Load the correct size paper or change thepaper size in for or . For details, see “If CORRECT PAPER> is displayed,” on p. 9-18.LOAD PAPER No paper is loaded in the paper cassette ormultipurpose tray when copying or printing.Load paper correctly. Then press [OK] whenusing the paper cassette.MEMORY FULL The machine’s memory becomes full whenscanning copy jobs.Press any key on the operation panel torelease the error.OUT OF TONERCHANGE TONERThe toner ran out completely. Replace the toner cartridge.PAPER JAM Paper jams have occurred in the machine.appears alternately.Clear the paper jam (See “Clearing Jams,” onp. 9-2) and reload paper in the paper cassetteor multi-purpose tray. The cover must beopened and closed to resume the current job.PAPER JAMOPEN REAR COVERPaper jams have occurred in the machine.appears alternately.Clear the paper jam (See “Clearing Jams,” onp. 9-2) and reload paper in the paper cassetteor multi-purpose tray. The cover must beopened and closed to resume the current job.PLEASE WAIT This message appears when turning on themain power switch, or when the machine isnot ready for printing.Wait until the message disappears.REMOVE MP PAPER Paper is loaded in the multi-purpose tray. Remove the paper from the multi-purposetray. The machine will not print the USERDATA LIST when paper is loaded in the multi-purpose tray. It will be stored in memory. |
