Canon LV-7392A Command List

Also see for LV-8227M: User manual Command specifications

Contents

Canon LV-7392A Command List Manual pdf 39 page image

LV-7292A/LV-7297A/LV-7392A/LV-7393A/LV-7398A/LV-8227A/LV-7292M/LV-7297M/LV-8227MExpand Serial Command Functional Specifications-33-8.10.9 CF_LOGO CommandCommand “CF_LOGO_%1_%2”[CR]%1 “0000”-”9999” ----------------- Set LOGO PIN CODE directly%2“OFF” ---------------------------- Disable Logo function“DFLT” --------------------------- Display Default Logo“USER” -------------------------- Display Captured Logo“UP” ----------------------- The same operation as pressing Up key or Left key“DN” ----------------------- The same operation as pressing Down key or Right keyDetailsSet / Cancel LogoThe value set by this command is stored in EEPROM and its setting is effectiveeven after ALL is OFFThis command is available in normal Power ON status.%1--- Set LOGO PIN CODE- When LOGO LOCK is in operationPIN CODE is correct ------------------ Command is valid (Acceptable)PIN CODE is incorrect ---------------- Command is invalid (Error Code “102”)PIN CODE is out of %1 range ------ Command is invalid (Error Code “? “)-When LOGO LOCK is not in operationPIN CODE is within %1 range ------ Command is validPIN CODE is out of %1 range ------ Command is invalid (Error Code “? “)Note) Receiving correct LOGO PIN CODE while LOGO LOCK is in operationenables to change LOGO setting, but it does not release LOGO LOCK. (LOGOLOCK continues.)Projector returns Error Code “101” by receiving USER in %2 when capture hasnot operated.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.10.10 CF_HDMISETUP CommandCommand “CF_HDMISETUP_%1”[CR]%1 “NORMAL” ----------------------- Set Normal mode“ENHANCED” ------------------- Set Enhanced modeDetailsSet HDMI Image setup. This command is available in normal Power ON status.The value set by this command is stored in EEPROM and its setting is effectiveeven after ALL is OFFResponse Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.10.11 CF_HDMISOUNDCommandCommand “CF_HDMISOUND_%1”[CR]%1 “HDMI” ----------------------- Set PCM Digital Sound Inpout“EXTERNAL” -------------- Set External sound InputDetailsSet HDMI Sound setup. This command is available in normal Power ON status.The value set by this command is stored in EEPROM and its setting is effectiveeven after ALL is OFFResponse Acceptable “000”[CR]Unacceptable “Error Code”[CR]