Canon LV-WX300 User Manual

Contents

Canon LV-WX300 User Manual Manual pdf 35 page image

35ENGLISHMagnifying and searching for detailsIf you need to find the details on the projected picture, magnify the picture. Use the direction arrow keysfor navigating the picture.• Using the remote control1. Press D.ZOOM +/- to display the Zoom bar.2. Press D.ZOOM + to magnify the center of the picture. Press thekey repeatedly until the picture size is suitable for your need.3. Use the directional arrows ( , , , ) on the projector orremote control to navigate the picture.4. To restore the picture to its original size, press AUTO PC. Youcan also press D.ZOOM -. When the key is pressed again, thepicture is further reduced until it is restored to the original size.• Using the OSD menu1. Press MENU and then press / until the DISPLAY menu is highlighted.2. Press to highlight D.ZOOM and press OK/IMAGE. The Zoom bar is displayed.3. Repeat steps 2-4 in the section of "Using the remote control" above. Or if you are using the projectorcontrol panel, continue to the following steps.4. Press on the projector repeatedly to magnify the picture to a desired size.5. To navigate the picture, press OK/IMAGE to switch to the panning mode and press the directionalarrows ( , , , ) to navigate the picture.6. Use the directional arrows ( , , , ) on the projector or remote control to navigate the picture.7. To reduce size of the picture, press OK/IMAGE to switch back to the zoom in/out functionality, andpress AUTO PC to restore the picture to its original size. You can also press repeatedly until it isrestored to the original size.The picture can only be navigated after the picture is magnified. You can further magnify the picturewhile searching for details.Selecting the aspect ratioThe 'aspect ratio' is the ratio of the image width to the image height. Most analog TV and computers are in4:3 ratio, and digital TV and DVDs are usually in 16:9 ratio.With the advent of digital signal processing, digital display devices like this projector can dynamicallystretch and scale the image output to a different aspect than that of the image input signal.To change the projected image ratio (no matter what aspect the source is):1. Press MENU and then press / until the DISPLAY menu is highlighted.2. Press to highlight Aspect.3. Press / to select an aspect ratio to suit the format of the video signal and your displayrequirements.