| 
2-3Specifying the Network Settings210 Press [ (-)] or [ (+)] to select or .● If you want to specify the ethernet driver settings automatically:❑ Select ➞ press [OK].● If you want to specify the ethernet driver settings manually:❑ Select ➞ press [OK].❑ Press [ (-)] or [ (+)] to select ➞ press [OK].❑ Press [ (-)] or [ (+)] to select or for specifying the desiredcommunication mode ➞ press [OK].❑ Press [ (-)] or [ (+)] to select ➞ press [OK].❑ Press [ (-)] or [ (+)] to select <10 BASE-T> or <100 BASE-TX> for specifying the desired ethernet type ➞press [OK].11 Press [Stop/Reset] to return to the standby display.■ Checking the Current Network SettingsYou can check the network settings of the machine. Settings specified from the operation panel becomeeffective after the machine is restarted, after the procedure.1 Press [Menu].2 Press [ (-)] or [ (+)] to select ➞ press [OK].3 Press [ (-)] or [ (+)] to select ➞ press [OK].4 Press [ (-)] or [ (+)] to select , , or fordisplaying the setting you want to check ➞ press [OK].5 Press [Stop/Reset] to return to the standby display.Settings Using ARP/PING Commands1 Start up the MS-DOS prompt or the Command prompt on your computer.2 Execute the following command to add a static entry to the arp table.arp -s IP Address: Specify the IP address you want to allocate to the machine. The IP address consists of 4numbers ranging from 0 to 255, using periods (.) as separators. (ie. 172.20.88.125)MAC Address: Specify the MAC address of the machine. Every second digit is separated by “-”. (ie.00-00-85-05-70-31)Input Example: arp -s 172.20.88.125 00-00-85-05-70-313 Execute the applicable command below to set the IP address for the network board.ping -l 479Input Example: ping 172.20.88.125 -l 479NOTE• The character “-l” is the alphabet letter “L.”• The Subnet Mask and Gateway Address are set as <0.0.0.0>.The preparation for the machine’s protocol settings are complete. |
