Canon MP980 Series Network Setup Manual

Also see for MP980 series: Supplementary guide Getting started Manual Easy setup Manual

Contents

7ENGLISH5.10 The The Card Slot is already mapped as Network Drive to this computer isdisplayed during setupThe Card Slot has already been mapped as the network drive. The Card Slot is already available.Click OK to close the dialog, then click Next on the Network Setup of the Card Slot dialog box.5.11 The Cannot map any more drives, because all the drive letters are assigned isdisplayed during setupClick Skip to complete the setup. After software installation is complete, remove any drive letterand try the network setup of the Card Slot again using the Canon IJ Network Tool.7 The admin password set to the machine was forgotten7.1 The admin password set to the machine was forgottenRestore the machine setting to factory default.All settings previously set will be lost after initialization. Set up the machine again to use it. Fordetails, refer to “6.1 Re-setting the machine” on page 7.6.1 Re-setting the machineRestore the machine to the factory default and set up the machine again. For details, refer to“Restoring the Machine to the Factory Settings” on page 8.•To set up the machine again, follow the procedures in “Install the Software” and onward in theprinted manual: Getting Started.If you have changed the connection method via Change wireless/wired in the machine’s LANsetting, you need to setup the machine again. To do so, follow the procedures in “Install theSoftware” and onward in the printed manual: Getting Started.•8 Changing the port name8.1 Changing the port nameTo change the port name, click View Setup Results in the Setup Completion dialog box, thenclick Set Port Name.The Set Port Name dialog box is displayed, where you specify the port name. By changing theport name, you can change the name of the machine. When you set up an additional computer touse the machine whose port name you changed, the machine is displayed with the changed portname. When two or more computers are set up, the changed name is displayed. When multiplecomputers or machines are present, this can be used to change the name to one that is easy toremember.Port NamePort names should consist of alphanumeric characters and be no longer than 21 characters,excluding the prefix. The port name includes the fixed prefix “CNBJNP_”, which you do not needto enter.5.12 The Timeout error screen is displayed during WPS setupThis screen is displayed when WPS setup is not completed within the specified time (2 minutes forthe push button method, and 10 minutes for the PIN code method). Retry following the proceduresbelow.When using the push button method•a) Press the OK button.The WPS setting screen returns.b) Select Push button method and press the OK button.c) Press the OK button.d When the access point is ready, press the OK button on the machine, then press the WPSbutton on the access point within two minutes.When using the PIN code method•a) Press the OK button.The WPS setting screen returns.b) Select PIN method and press the OK button.A new PIN code appears.c) Set the new PIN code to the access point or computer.6 Re-setting the machine