40Adjusting the VolumeWhen you use the LCD screen for playback, the camcorder plays back the sound viabuilt-in speaker. The speaker does not sound when you close the LCD panel. Useheadphones when using the viewfinder.Adjusting the Speaker VolumeTurn the SET dial up to increase the volume, and downto lower the volume.• A volume bar appears for 2 seconds.• You can turn off the volume completely by turning the SET dialdown until “OFF ” appears. Turn the SET dial up to increase thevolume again.Adjusting the Headphones VolumeThe headphones terminal also serves as AV terminal. Headphones can only be usedwhen “ ” is displayed on the screen. If not, change the setting following the procedurebelow.1. Press the MENU button and select [VCR SETUP].Select [AV/PHONES ], set it to [PHONES ] andpress the MENU button.2. Turn the SET dial to increase the volume, and downto lower the volume. The speaker does not sound when “ ” is displayed. Do not connect headphones unless “ ” is displayed as it produces noise. You can also adjust the headphones volume during recording.CAMERA PLAY (VCR) CARD CAMERA CARD PLAYCAMERA PLAY (VCR) CARD CAMERA CARD PLAYMENU( 70) VCR SETUP AV/PHONES •• AV(phones) terminalSET dialSpeaker
