Speedlite on MiniTT1 in camera shoein modeFlash on CameraThis mode is identical to the previous page, adding a flashto the top hot shoe of the MiniTT1. All remote E-TTL IIflashes and the master flash will be treated as one zone oflight and will fire at the same power level which is chosenautomatically by the camera.IMPORTANT: The Speedlite in the MiniTT1’s top shoemust be in mode, otherwise the remote flasheswill not trigger. Wait for the camera to sleep, turn OFF theMiniTT1, or remove the flash from the shoe beforeengaging mode.O Please read your Canon manuals for the steps to enter mode.1. Slide the MiniTT1 Transmitter onto the camera and tightenthe locking ring.2. Slide a Canon Speedlite set for onto the MiniTT1 and secure its locking shoe.3. Slide the remote Speedlite onto a FlexTT5 Transceiver, tighten the locking ring, and secure theFlexTT5. Repeat for each remote Speedlite. The remote Speedlites should be set to normalETTL mode, not or .4. Trigger normally.NOTE: You can use a 430EX (I or II) as a single zone master! These flashes do not have a mastermode, and cannot usually trigger remote E-TTL II flashes. Enable Force TTL Master Mode in thePocketWizard Utility and they can.This mode also benefits the 580EX (I or II) by reducing the “flickering pre-flash” normallyassociated with master mode. On that flash, set the wireless selector to and enableForce TTL Master Mode. See the PocketWizard Utility help for more information.13Basic Wireless E-TTL II: MiniTT1 OO FlexTT5 (cont’d)
